Optional) Neteco Management; Neteco6000 Management; Connecting The Communications Cable; Setting Neteco Parameters - Huawei FusionModule500 V100R021C10 User Manual

FusionModule500 Smart Mini Data Center
User Manual
7.
8.
Step 3 Configure a video recording plan.
1.
2.
3.
4.
5.
----End

5.3.12 (Optional) NetEco Management

5.3.12.1 NetEco6000 Management

5.3.12.1.1 Connecting the Communications Cable

Procedure
Step 1 Connect the communications cable to the WAN1 port on the ECC800-Pro.
Figure 5-36 Connecting the communications cable
----End

5.3.12.1.2 Setting NetEco Parameters

When the smart module can be connected to the NetEco, perform the following
steps to configure parameters.
Procedure
Step 1 Apply for a fixed IP address to the equipment room network administrator.
Issue 01 (2020-11-30)
Click Finish.
Preview live video. On the iClient home page, click Live and drag a camera to
the live video pane. If the live video can be properly played, the camera is
successfully connected.
Choose System Management > Device Management > Micro Edge on the
iClient home page.
Right-click an IVS1800 and choose Storage Management.
Click the Server Recording tab. The tab page for configuring a server-based
recording plan is displayed.
Configure a video recording plan.
NO TE
If you set the recording plan policy to All, you do not need to set the recording plan time.
Click Save.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
160