Commissioning A C3220 Camera (Sd Card Configured) - Huawei FusionModule500 V100R021C10 User Manual

FusionModule500 Smart Mini Data Center
User Manual
Follow-up Procedure
After the alarm is cleared, you need to manually close the door. After the door is
closed, the door open alarm is cleared.

5.3.10 Commissioning a C3220 Camera (SD Card Configured)

Context
If the IVS1800 is not configured and an SD card is chosen, perform the following
procedure.
Procedure
Step 1 Log in to the camera WebUI.
1.
2.
Step 2 For details about how to commission the camera and set parameters, see the
documents delivered with the device or the documents obtained by referring to
the "Preparing Documentation" section.
1.
2.
3.
Issue 01 (2020-11-30)
Configure the PC IP address and the camera IP address in the same network
segment. Enter the camera IP address (192.168.0.120 by default) in the
address bar of the Internet Explorer and press Enter.
Enter the preset user name admin and the preset password HuaWei123, and
click Log In.
Preview the site situation in real time and check the camera coverage through
videos. Adjust the lens if necessary.
Set IPv4 address, IPv4 subnet mask, and IPv4 gateway address to the
planned values.
Figure 5-18 Setting the IP address of the camera
Format the SD card.
a. Choose Settings > System Configuration > Storage Management.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
143