Replacing A Hard Disk For The Ivs1800 - Huawei FusionModule500 V100R021C10 User Manual

FusionModule500 Smart Mini Data Center
User Manual
Procedure
Step 1 Turn off the power switch of the IVS1800, disconnect the power supply of the
IVS1800, remove the cables from the IVS1800, label the cables, and record the
original connection positions of the cables.
After removing cables, wrap exposed terminals with insulation tape and do not
block cable labels. If cable labels are blocked, cables may be connected incorrectly.
Step 2 Remove the faulty IVS1800 from the cabinet.
Step 3 Carry the device to the cabinet. Ensure that the mounting ears at both sides of the
device are tightly attached to the mounting bars in front of the cabinet. Use one
hand to hold the device. Use the other hand to thread M6 screws through the
slotted holes on the mounting ears. Use a Phillips screwdriver to tighten the M6
screws on the mounting ears. Each mounting ear uses two M6 screws.
Figure 6-16 Installing a device
Step 4 Reconnect the cables to the new IVS1800.
Step 5 Turn on the power switch of the IVS1800.
Step 6 Commissioning the IVS1800. If the video recording function works properly after
commissioning, the IVS1800 is functional.
----End

6.4.3.7 Replacing a Hard Disk for the IVS1800

Prerequisites
●
●
●
●
Issue 01 (2020-11-30)
NO TICE
A hard disk needs to be replaced.
Data in the hard disk has been backed up.
A spare hard disk of the same model is available and functional.
Before replacing a faulty disk, ensure that the power switch on the rear panel
is off and disconnect the power cable to power off the device.
Copyright © Huawei Technologies Co., Ltd.
6 O&M
223