Setting Iec104 Parameters - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
Mode for the SmartLogger to connect to the IEC103 device: When the SmartLogger connects
to the NMS, it transparently transmits IEC103 device information to the NMS.
Because of permission restriction, log in as Advanced User. Choose Settings > IEC103 to
access the target page.
Figure 7-50 Setting IEC103 parameters

7.10.2.7 Setting IEC104 Parameters

IEC104 is a general standard protocol without a security authentication mechanism. To reduce
network security risks, connection to a third-party NMS over the IEC104 protocol is disabled
by default. The SmartLogger can connect to a maximum of five third-party NMSs.
If the SmartLogger connects to a third-party NMS over the IEC104 protocol, IEC104
parameters must be correctly set to enable the third-party NMS to monitor the running status
of devices connected to the SmartLogger.
Because of permission restriction, log in as Advanced User. Choose Settings > IEC104 to
access the target page.
Issue 12 (2019-01-15)

Third-party devices and Huawei devices must be connected to different ports of the SmartLogger.
Otherwise, the communication will be abnormal.

The value of IEC103 IP must be consistent with the IP address of the NMS.
Copyright © Huawei Technologies Co., Ltd.
7 WebUI
226