Setting Rs485 Parameters - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
Figure 7-45 Setting Ethernet parameters
If the SmartLogger connects to the Internet through a router, note the following when setting
Ethernet parameters:




7.10.2.2 Setting RS485 Parameters

Because of permission restriction, log in as Advanced User or Special User. Choose
Settings > RS485 to access the target page.
Figure 7-46 RS485 parameters
Issue 12 (2019-01-15)
Set the gateway address to the IP address of the router.
Ensure that the IP address of the SmartLogger is in the same network segment as the
gateway address.
Set the domain name server (DNS) address to the IP address of the router or obtain the
DNS address from the network provider.
If the IP address is changed, you need to use the new IP address to log in to the system.
Copyright © Huawei Technologies Co., Ltd.
7 WebUI
221