Huawei SmartLogger1000 User Manual page 152

SmartLogger1000
User Manual
LCD
Issue 12 (2019-01-15) Copyright © Huawei Technologies Co., Ltd.
Operation Procedure
4. Choose Device Mgmt. and press

Perform step 5 to enable the SmartLogger
to automatically search for devices.
 Perform step 6 to add devices to the
SmartLogger.

Perform step 7 to remove a single device.
 Perform step 8 to remove devices in
batches.

Perform steps 9-12 to automatically assign
addresses.
 Perform step 13 to import a configuration
file.

Perform step 14 to reset alarms.
 Perform steps 15-17 to start or shut down
inverters in batches.

Perform step 18 to reset inverters in
batches.
5. Choose Auto. Search and press
Before performing the automatic search,
ensure that all the devices can normally
communicate with the SmartLogger.
NOTE
 After you add, delete, or replace a device, or
change the RS485 address, search for devices
again.
 If a device is added, search for the device on the
SmartLogger or restart the SmartLogger and
then search for the device on the NMS.
6 User Interface
.
.
139