Typical Cable Connection Scenarios - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
3. Energy
production
data
4. Status
information
Buttons
There are four buttons on monitoring panel. They are the Return button, Cursor Up button,
Cursor Down button, and Confirm button from left to right.
Table 2-3
Table 2-3 Button description
Buttons
ESC

2.4 Typical Cable Connection Scenarios

Overview


Issue 12 (2019-01-15)
 Allows you to view the total energy production from 0:00 to the current
time by all the inverters connected to the SmartLogger.
 Allows you to view the emission reduction of CO
energy yield of the current day.
 Allows you to view the total output power by all the online inverters
connected to the SmartLogger at the present.
Allows you to view the number of the major alarms, minor alarms, and
warnings of all the inverters connected to the SmartLogger. When remote
grid dispatching is enabled, you can view the current status of grid
dispatching.
describes the button functions.
Name
Return
button
Cursor
Down
button
Cursor Up
button
Confirm
button
The backlight lasts 120s after you press any button.
The cable from the busbar to the knife switch needs to be prepared by yourself.
Recommended cable: three-core multi-wire (L1, L2, and L3) cable with the operating
voltage to the ground not less than 600 V and the cross sectional area of a single core
2
wire being 4 mm .
The cable from the knife switch to the miniature circuit breaker (MCB) needs to be
prepared by yourself. Recommended cable: three-core multi-wire (L1, L2, and L3) cable
with the operating voltage to the ground not less than 600 V and the cross sectional area
of a single core wire being 4 mm
Copyright © Huawei Technologies Co., Ltd.
Functions
Allows you to return to the last page or end an
operation.
Allows you to go to the upper-level menu or set
parameters.
Allows you to go to the lower-level menu or set
parameters.
Allows you to go to the menu or confirm the value.
2
.
2 Overview
corresponding to the
2
10