Huawei SmartLogger1000 User Manual page 135

SmartLogger1000
User Manual
LCD
Issue 12 (2019-01-15) Copyright © Huawei Technologies Co., Ltd.
Operation Procedure
12. Set Modbus TCP parameters and then
press .

Modbus-TCP is a general standard
protocol without a security authentication
mechanism. Therefore, the function of
connecting to a third-party NMS using
Modbus-TCP is disabled by default to
reduce network security risks. Parameters
must be set correctly to enable the
function.

In most cases, set Address mode to
Comm. Address. If the devices connected
to the three RS485 ports of the
SmartLogger have duplicate addresses, you
must set Address mode to Logical addr..
 Set the client IP addresses correctly.
13. Press , choose IEC103, and press
14. Set IEC103 parameters and then press
NOTE
IEC103 is a general standard protocol without a
security authentication mechanism. Therefore, the
function of connecting to the NMS using IEC103 is
disabled by default to reduce network security risks.
Parameters must be set correctly to enable the
function.
6 User Interface
.
.
122