Huawei SmartLogger1000 User Manual page 222

SmartLogger1000
User Manual
No Paramet Function
. er Name
7 Maximum Specifies the
DC PV-PE voltage
voltage when Operation
Mode is set to
Normal or
Commissioning.
Maximum Specifies the
8
output highest output
voltage voltage of the
PID module when
Operation Mode
is set to Normal
or
Commissioning.
IMD Specifies whether
9
access the PID module
and insulation
monitor device
(IMD) can
operate in cycle
mode.
10 Periodic Specifies the
PID operating time
runtime segment of the
PID module when
the PID module
and IMD operate
in cycle mode.
Periodic Specifies the
11
IMD operating time
runtime segment of the
IMD when the
PID module and
IMD operate in
cycle mode.
12 IMD Dry contact No.
control over which the
dry SmartLogger
contact controls the IMD
Issue 12 (2019-01-15)
Paramet Description
er Value
500–1500 If the PV module type is P, the parameter value indicates
V the highest DC voltage between PV+ and PE. If the PV
module type is N, the parameter value indicates the
highest DC voltage between PV– and PE.
If the offset mode is PV/PE, the parameter value indicates
0–500 V
the highest DC output voltage between PV and PE. If the
offset mode is N/PE, the parameter value indicates the
highest DC output voltage between N and PE.
Select Enable if you allow the PID module and IMD
Enable
operate in cycle mode.
Only the IMDs of mainstream suppliers such as DOLD
and BENDER are supported,and the IMDs must have
enabled dry contacts.
NOTICE
Only when IMD access is set to Enable, can you set Periodic
PID runtime, Periodic IMD runtime, and IMD control dry
contact.
Disable Select Disable if you forbid the access of IMDs.
60–480 The IMD is shut down when the PID module is operating.
minutes
15–480
The PID module is standby when the IMD is operating.
minutes
DO1, PID01: Set appropriate ports based on the cable
DO2, and connections between the IMD and the SmartLogger.
DO3
Copyright © Huawei Technologies Co., Ltd.
7 WebUI
209