Huawei SmartLogger1000 User Manual page 214

SmartLogger1000
User Manual
Running parameters
Figure 7-22 Running parameters
SN list
Figure 7-23 SN list
Issue 12 (2019-01-15)
 Baud rate is set to 115200 by default, which provides optimal communications performance and
does not need to be changed.
 If Anti-crosstalk is set to Enable, the inverter with a PLC STA in the SN list can access networking.

Parameters Box-type transformer No. and Winding No. can be set for the PLC CCO with
SUN2000 V100R001C72SPC100 or later versions. In multi-split transformer scenarios, specify
Winding No. based on the actual winding number of the SmartLogger connected to the transformer.
When the box-type transformer and winding numbers of the inverter with an STA are consistent with
those of the PLC CCO, the inverter can access networking.
 The SN list displays the relevant information of the inverters with PLC STAs that can be connected.

Tap Synchronize, and synchronize the box-type transformer and winding numbers of the PLC CCO
to the inverter.
Copyright © Huawei Technologies Co., Ltd.
7 WebUI
201