Connecting An Ethernet Network Cable - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual

4.8 Connecting an Ethernet Network Cable

Context
The SmartLogger can be connected to an Ethernet switch, router, or POE module. It can also
be connected to the Ethernet electrical port of a PC directly or through a hub. Select the
connection device based on the actual networking scenario.
Procedure
Step 1 Connect one end of the delivered network cable to the Ethernet electrical port of a device.
Step 2 Connect the other end of the network cable to the FE port of the SmartLogger, as shown in
Figure
Figure 4-29 Connecting an Ethernet network cable
Issue 12 (2019-01-15)
If the delivered cable is too short, pay attention to the following when preparing a cable:
 Select CAT 5E or a higher-class shielded network cable.
 It is suggested that the cable length is less than or equal to 100 meters.
4-29.
 A POE module can be connected only to the DATA port of the SmartLogger.

The default IP address of the SmartLogger is 192.168.0.10, the default subnet mask is 255.255.255.0,
and the default gateway is 192.168.0.1.
 If the SmartLogger is connected to a PC directly or through a hub, the IP addresses of the
SmartLogger and PC must be in the same network segment. For example, if the IP address of the
SmartLogger is 192.168.0.10, the IP address of the PC can be 192.168.0.11. The subnet mask and
the gateway of the PC should be consistent with those of the SmartLogger.
 If the SmartLogger connects to the PC through a network device (for example, a router), set the IP
addresses for the SmartLogger and network device to be in the same network segment. Correctly set
the gateway of the SmartLogger to ensure that the SmartLogger can normally communicate with the
network device.
Copyright © Huawei Technologies Co., Ltd.
4 Electrical Connections
49