Alarms - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
No. Symptom
8 Emails
cannot be
received.

9.3 Alarms

This topic describes the common faults in the SmartLogger and the troubleshooting measures.
Table 9-2
Table 9-2 Alarms
Alarm Alarm
ID
1100 Abnorm
al
P-Contro
l
1101 Abnorm
al
Q-Contr
ol
Issue 12 (2019-01-15)
Possible Cause
1. The SmartLogger cannot communicate
with the email server.
2. Ethernet parameters are not properly
set.
3. Email parameters are not properly set.
describes the common faults and the troubleshooting measures.
Alarm Alarm
Severity Sub-ID
Major 1
Major 1
Copyright © Huawei Technologies Co., Ltd.
Measures
1. Connect the Ethernet network port of
2. Check that the Ethernet parameters are
3. Check that the Email parameters are
Causes Measure
1. Check whether the cable connections to
Under the active
power AI
2. Enter the active power Dry contact
remote control
mode, the
feedback
command data
of the AO port
cannot be read
due to the
ADAM fault,
power
disconnection,
or abnormal
link.
1. Check whether the cable connections to
Under the
reactive power
Dry contact 2. Enter the reactive power Dry contact
remote control
mode, the four
DI ports read
commands
beyond the
configuration.
the SmartLogger to the PC or router.
correctly set.
correctly set.
the DI ports are correct.
remote control configuration page and
check the mapping table of the current
DI signal configuration. Contact the
power grid company to check the
completeness of the combination
configurations in the mapping table and
check whether the configurations
comply with the requirements of the
power grid company.
the DI ports are correct.
remote control configuration page and
check the mapping table of the current
DI signal configuration. Contact the
power grid company to check the
completeness of the combination
configurations in the mapping table and
check whether the configurations
comply with the requirements of the
power grid company.
9 Maintenance
274