SmartLogger1000
User Manual
LCD
Here use the pages displayed when you
log in to the SmartLogger as Advanced
User.
(The inverter upgrade screen is used as an
example.)
----End
Issue 12 (2019-01-15)
Copyright © Huawei Technologies Co., Ltd.
Operation Procedure
4. Choose USB Expansion and press
NOTE
Before this operation, connect the USB flash
drive to the USB port.
The system takes 5 to 10 seconds to detect the
USB flash drive. Then perform the following
steps.
5. Choose Firmware Upgrade, and press
6. Press
to select a specific device.
The SmartLogger and the inverters connected
to it can be upgraded.
The SUN2000 (1-7) on the left indicates that
this inverter connects to the Port 1 of the
SmartLogger and the communications address
for the RS485 port is 7.
7. After checking that Target Version is
correct, press
.
NOTICE
For the SUN2000, its firmware can be upgraded
only if the device status is On-grid or Shutdown.
Check the device status before firmware upgrade.
The SmartLogger, inverter, PLC, or PID will
restart after being upgraded.
6 User Interface
.
.
129