Disabling Reactive Power Output; Dry Contact Remote Control - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual

8.3.1 Disabling Reactive Power Output

If the PV plant is not required to adjust the voltage at the grid-tied point or perform reactive
power compensation, the inverter can run with pure active power output. In this case, set
Reactive power control mode to Disable reactive power output.
Figure 8-9 Reactive power control

8.3.2 Dry Contact Remote Control



Set Reactive power control mode to Dry contact remote control.
Issue 12 (2019-01-15)
If ports of DI1–DI4 have been configured in
contact remote control is unavailable.
Before setting dry contact remote control, ensure that the SmartLogger connects to a
correct ripple control receiver. For details, see
Ripple Control Receiver.
Copyright © Huawei Technologies Co., Ltd.
8 Power Grid Scheduling
7.10.6 Dry contact remote
4.10 Connecting the SmartLogger to a
shutdown, Dry
262