GE MiCOM P40 Agile Technical Manual page 610

Hide thumbs Also See for MiCOM P40 Agile:

Table of Contents

P44x/EN VH/Hb6

Branch B1.x : New Hardware Platform (150 MHz coprocessor Board -2nd rear port-Triptime= 1,1 Cycle - 48 samples/T) & New functions (32N & 59N)

Note: The software version / hardware version / model number can be found through the setting in "system data" via MiCOM S1 or LCD front panel.

Patch 09 is included with MiCOM S1 version V2.11

Note 2: Version B1.0, to B1.3 not distributed (mandatory upgrade). Version B1.4 to B1.7: Recommanded upgrade.

Relay type: P441, P442, P444

New platform/model 080C/coprocessor board at 150 MHz/PW (32N)/CVTS

(59N) new functions/ Px4X with Px3x in IEC103 / Retrip CB/Ffu/31st December

for Drec/I Brok.cond./DEF polar.

Synchrocheck ext correction & PPhase ref & L-Live / 32N correction / Line

angle<55° / Voltage memory / Power swing & Z glitch

Disturbance compressed & not compressed function and communication

correction/2UN Vref Sync/Zn-Zn+1 with +30msec

Synchro TP bus/Optos taging in event/ZSP angle/Dynamic management Bus-

Line for checksync

New plateform /Timesync cell in ModBus /DNP3

CB close command is applied 2 time from DNP3

Fault location-Settings group by opto-DNP3 & model N°

32N corrected (5Amp) -

Primary measurement & Im

ModBus/ VTS alarm using V2

Full Description of changes

Hardware / Software-Version

MiCOM P40 Agile P442, P444

S1 Compatibility

V2.09 + patch*

Troubleshooting