Siemens hipath 1100 Service Manual page 165

For internal distribution only
3. Click "Install. "
A window will appear where you can select the software to be installed
4. Install your selected software components sequentially. For programming the Hi-
Path 1100 system, the following applications must be installed:
HiPath 1100 Manager E
●
CommServer (installs automatically).
●
5. After installation of each component, a message is displayed indicating that the
installation was successfully completed. Select "Finish" to complete the instal-
lation.
6. Select "Close" to close the installation window. Installation is then completed
and the computer has to be restarted.
7 . Following the boot sequence, configure the CommServer. Right-click the Com-
mServer icon on the Windows status bar and select Properties. Specify these
settings:
Type of connection: ISDN connection
●
Phone #: ---
●
Your MSN: ---
●
8. Exit CommServer. When a HiPath 1100 application is activated, the server starts
automatically.
USB Interface without a CAPI Interface
If in addition to administering the HiPath 1100 system you also wish to use online ser-
vices on your computer, you need to install specific USB drivers and CAPI applica-
tions from the "CallBridge for Data" software package. This will enable communica-
tions between your computer and the system.
If CAPI drivers or an ISDN card from other manufacturers are already installed on the
system, they must be completely uninstalled before installing "CallBridge for Data."
Since the installation of these components starts automatically once a USB cable is
connected, the CallBridge for Data software must be first configured as follows:
Procedure:
1. Check whether the HiPath 1100 system is turned on and the computer has re-
started.
2. Insert the system CD in the CD drive If Auto-Run has been configured, minimize
the installation window on the Windows status bar.
3. In Windows Explorer, go to the directory:
<CD Drive>:\Software\CAPI Drivers
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Starting the Programming Mode
Operation
6-13