Hipath1120/1130/1150 Wall Mounting Instructions; Figure 4-6 Hipath 1130/1150 System Installation Overview - Siemens hipath 1100 Service Manual

Installation
Getting to Know your Systems
Components Location
Figure 4-6

4.5.3 HiPath1120/1130/1150 Wall Mounting Instructions

Step
1.
2.
3.
4.
5.
6.
4-8
HiPath 1130/1150 system installation overview
Procedure
Drill a hole in the wall at a height of 4.10 ft (1.25 m) from the floor.
Place the bushing over the hole then insert the screw and tighten it until
only 0.19" (5 mm) protrude.
Hang the system at the top of ➀, on the screw (see Figure 4-7 and Figure
4-8).
Mark additional holes for washers ➁ and remove the system.
Drill the remaining holes as marked, install washers and screws then
tighten them letting 0.19" (5 mm) protrude.
Hang the system again and align it by tightening the lower screws.
For internal distribution only
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual