Siemens hipath 1100 Service Manual page 168

Operation
Starting the Programming Mode
Windows ME
1. The Add New Hardware Wizard window appears. A message will appear indicat-
ing that Setup will search for new drivers for the HiPath 1000. Choose "Specify
the location of the driver (Advanced)" and click "Next."
Figure 6-9
2. Select the option "Search for the best driver for your device (Recommended)."
3. Select the "Specify a location:" checkbox and click "Browse" to select the direc-
tory where the uncompressed CallBridge for Data is stored (e.g., C:\Temp).
4. Click "Next" to proceed.
Figure 6-10
5. A message will appear indicating that Setup will search for a driver for CallBridge
for Data (Eval). Click "Next" to proceed.
6. A message appears confirming that the CallBridge for Data (Eval) installation was
completed. Click "Finish."
7 . A message will appear indicating that Setup will search for a driver for the HiPath
1000. Repeat hardware driver installation (steps 1 through 6) for the following
components:
HiPath 1000 Virtual COM Port
●
HiPath 1000 (CAPI Interface).
●
6-16
Windows ME - Specify installation folder
Windows ME - USB/CAPI driver installation location
For internal distribution only
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual