Programming An Extension - Siemens hipath 1100 Service Manual

For internal distribution only

7.2.3 Programming an Extension

Pickup Groups (43)
You can classify extensions in up to 16 Pickup Groups so that an extension from one
group can answer calls that ring at other extensions in the same group.
You can also add extensions to an existing Pickup Group.
Call Groups (CG) (13)
This setting groups extensions in Call Groups (CG) that can be accessed through
numbers 770 to 779. Whenever this number is dialed, every telephone in the group
rings until one of them answers.
Alert Ring Timeout for Pickup Groups (035)
Incoming calls are signaled on standard telephone sets within a pickup group (Code
43); in telephones without a display they are signaled by an alert ring signal. The du-
ration of the ring tone can be specified.
Activating Callback/Urgent Call with Timeout (037)
When an extension or external number is busy, this configuration provides the means
for setting a timeout for activating the Callback or Urgent Call features after approxi-
mately 7 seconds.
Call Name/Number Display (039)
This setting specifies the type of Caller ID information that will be shown on the tele-
phone display.
UCD Subscriber Groups (023)
This setting creates a group of extensions that can receive internal and external calls.
A Subscriber Group is a group of extensions available for answering calls made to a
specific number assigned to it.
An internal or external call directed to this group will be answered by the extension
that has been free the longest.
In the event that all extensions in the group are busy external calls are routed to a
hold queue.
If Data Protection or Urgent Call Barring are activated for a specific extension in the
group, this function will be effective for all extensions in the Subscriber Group.
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Configuring the System Specifically for the Client
Comments about the System's Programming Codes
7-27