Select The Location For Installing The Equipment; Unpacking System Components - Siemens hipath 1100 Service Manual

Installation

Select the location for installing the equipment

4.3 Select the location for installing the equipment
Installation Location
The system's installation site has been previously selected and agreed to by the cli-
ent.
The following precautions must be taken:
Do not expose the equipment to any external heat source (e.g., sunlight, heat-
●
ers, etc.).
Do not expose the equipment to excess dust
●
Do not install the equipment in areas where there is a risk of condensation when
●
the equipment is in use. If condensation occurs, dry the equipment before start-
ing operation.
Do not install inside closets.
●
The power outlet for connecting the system's power supply must be located
●
close to the equipment and must be easily accessible.
Follow all environmental guidelines described in the chapter "System Data"
●
(see"Environmental Conditions" on page 2-9).
Warning
!
When using the RSA version, extension lines with a C/D interface must only be in-
stalled indoors. Only regular extensions (without a C/D interface) can be installed
outdoors.
Note 1: See Section "HiPath 1100 Configurations" on page 2-2 for more information regard-
ing system configurations.

4.4 Unpacking System Components

Procedure
Step
1.
2.
3.
4-4
Procedure
Check to see that all components listed on the receipt are included in the
package.
Inspect all items for any damage that may have occurred during transpor-
tation. If any damage occurred, report it immediately to the place of pur-
chase.
Discard packaging materials according to local and national environmental
regulations.
For internal distribution only
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual