Run Quick Test; Comments About The System's Programming Codes; Important Settings - Siemens hipath 1100 Service Manual

For internal distribution only
Table 7-20 Relay and sensor on the HiPath 1120
Programmed Cod
Functions e
*
Relay 75
Timer for Deactivat- 73
ing the Relay
External Ring for 071
Activating the Relay
* When playing music from an external music source all regulations relating to copyrights for the country in question have to
be followed.

7.1.1 Run quick test

Checking terminals
Check the display of each terminal (for Time and Date). If there is nothing on the
●
display, it means that there is a problem with the terminals or cables. Replace
the terminal or inspect cables.
Check analog terminals.
●
Checking to see if the systems starts up properly
Make random internal and external calls.
●

7.2 Comments about the System's Programming Codes

7.2.1 Important settings

Dialing Mode on an External Analog Line (19)
The system supports two dialing modes for external and absent lines (for unused ex-
ternal line slots):
DP - Dial Pulse
●
MF - Multifrequency (Tone)
●
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Intermediate Data
Extension
Configuring the System Specifically for the Client
Comments about the System's Programming Codes
Data to be
Programmed
1 - Switch
2 - Monoflop
3 - Invert
4 - Music on Hold
5 - External signal
000 to 255
(intervals of 0.5 s)
Completing Default
Data Entry
Automatic 1 - Switch
# instead of 002 - (1
number second)
Automatic None
7-21