Bosch Rexroth EFC 3600 Operating Instructions Manual page 111

DOK-RCON03-EFC-3600***-IT01-EN-P
Rexroth Frequency Converter EFC 3600
Simple PLC control is inactive.
● 1: Mode 1.
Simple PLC stops after one cycle. When PLC is in this mode, after the last stage the
frequency converter decelerates to 0.00 Hz and then a STOP signal is generated.
The frequency converter stops as configured in stopping mode.
● 2: Mode 2.
Simple PLC runs in cycle and stops when the stopping command is entered. When
PLC is in this mode, after the last stage the frequency converter decelerates to 0.00
Hz and then starts from the beginning of the PLC cycle.
● 3: Mode 3.
After one cycle, the frequency converter keeps running at the set frequency of the
last stage.
E2.31 Simple PLC time multiple
Setting range 1 ~ 60
Minimum unit 1
Factory default 1
The actual running time of each stage=[Stage x running time] * [E2.31].
[Stage x running time] has a possible maximum value of 6000.0s, the PLC time multipli‐
er [E2.31] has a maximum value of 60 and there are 8 possible stages (0-7), so the
maximum duration of one PLC cycle calculates to: 8*6000.0s*60=800 hours.
E2.35 Stage 0 action selection
011, 012, 013, 014, 021, 022, 023, 024, 031, 032, 033, 034, 041,
Setting range 042, 043, 044, 111, 112, 113, 114, 121, 122, 123, 124, 131, 132,
133, 134, 141, 142, 143, 144
Minimum unit 1
Factory default 011
E2.36 Stage 0 running time
Setting range 0.0 ~ 6000.0s
Minimum unit 0.1s
Factory default 20.0s
E2.37 Stage 1 action selection
See "Stage 0 action selection"
E2.38 Stage 1 running time
See "Stage 0 running time"
E2.39 Stage 2 action selection
See "Stage 0 action selection"
E2.40 Stage 2 running time
Bosch Rexroth AG
Parameter Settings
109/235