Instructions With Regard To Specific Dangers - Bosch Rexroth EFC 3600 Operating Instructions Manual

DOK-RCON03-EFC-3600***-IT01-EN-P
Rexroth Frequency Converter EFC 3600
CAUTION
CAUTION
2.6

Instructions with Regard to Specific Dangers

Protection Against Contact with Electrical Parts
This section only concerns devices and drive components with voltages of
more than 50 V. Contact with parts conducting voltages above 50 V can
cause personal danger and electric shock. When operating electrical
equipment, it is unavoidable that some parts of the devices conduct dan‐
gerous voltage.
DANGER
● Only those trained and qualified to work with or on electrical equipment are permit‐
ted to operate, maintain and repair this equipment.
● Follow general construction and safety regulations when working on electrical power
installations.
● Before switching on the device, the equipment grounding conductor must have been
non-detachably connected to all electrical equipment in accordance with the connec‐
tion diagram.
● Do not operate electrical equipment at any time, even for brief measurements or
tests, if the equipment grounding conductor is not permanently connected to the
mounting points of the components provided for this purpose.
● Before working with electrical parts with voltage potentials higher than 50 V, the de‐
vice must be disconnected from the mains voltage or power supply unit.
● With electrical drive and filter components, observe the following:
– Wait for 10 minutes after switching off power to allow capacitors to discharge be‐
fore beginning to work.
Safety Instructions for Electric Drives and Controls
Hot surfaces on device housing! Danger of injury!
Danger of burns!
Risk of injury by improper handling! Risk of bodily
injury by bruising, shearing, cutting, hitting, or im‐
proper handling of pressurized lines!
High electrical voltage! Danger to life, electric shock
and severe bodily injury!
Bosch Rexroth AG
13/235