Cfgnettuning - Dell PowerEdge M1000e Reference Manual

Example
racadm getconfig -g cfgCurrentIPv6LanNetworking
# cfgCurrentIPv6Enabled=1
# cfgCurrentIPv6AutoConfigWasUsed=1
# cfgCurrentLinkLocalAddress=fe80::21e:4fff:fe1f:5371/64
# cfgCurrentIPv6Address1=2009:123::e48f:9dd8:6f51:a669/64
# cfgCurrentIPv6Address2=fd88:1::21e:4fff:fe1f:5371/64
# cfgCurrentIPv6Address3=fd88:2::21e:4fff:fe1f:5371/64
# cfgCurrentIPv6Gateway=fe80::21c:23ff:fe77:6215
# cfgCurrentIPv6DNSServersFromDHCP6=1
# cfgCurrentIPv6DNSServer1=2009:123::1
# cfgCurrentIPv6DNSServer2=::

cfgNetTuning

This group enables users to configure the advanced network interface parameters. When configured, the updated settings may take
up to a minute to become active.
CAUTION: Use extra precaution when modifying properties in this group. Inappropriate modification of the properties in
this group can result in your RAC NIC become inoperable.
The following sections provide information about the objects in the cfgNetTuning group.
cfgNetTuningNicSpeed (Read or Write)
Specifies the speed for the CMC NIC. This property is used only if cfgNetTuningNicAutoNeg is set to 0.
Description
10, 100, or 1000
Legal Values
100
Default
cfgNetTuningNicAutoneg (Read or Write)
Enables auto negotiation of physical link speed and duplex. If enabled, auto negotiation takes priority over other
Description
values set in this group.
• 0 = Auto Negotiation is Disabled
Legal Values
• 1 = Auto Negotiation is Enabled
1
Default
Example
racadm getconfig -g cfgNetTuning
cfgNetTuningNicSpeed=100
cfgNetTuningNicFullDuplex=1
cfgNetTuningNicMtu=1500
cfgNetTuningNicAutoneg=1
cfgNetTuningNicFullDuplex (Read or Write)
Specifies the duplex setting for the NIC. This property is used only if thecfgNetTuningNicAutoNeg is set
Description
to 0 (disabled).
• 0 (Half Duplex)
Legal Values
133