Setled - Dell PowerEdge M1000e Reference Manual

•
Synopsis racadm setflexaddr -i <slotNum> 0|1
•
racadm setflexaddr -f <fabricName> 0|1
• -i <slotNum> — Enables or disables FlexAddress for the specified slot.
Input
• -f <fabricName> — Enables or disables FlexAddress for the specified fabric.
• <slotNum>= 1–16
• <fabricName>= A, B, C, iDRAC
– 0 : Disable
– 1 : Enable
• Disable flexaddress for slot 2.
Example
racadm setflexaddr -i 2 0
• Enable flexaddress for fabric A.
racadm setflexaddr -f A 1
• Disable flexaddress for fabric B.
racadm setflexaddr -f b 0
• Disable flexaddress for fabric iDRAC.
racadm setflexaddr -f idrac 0

setled

Description Sets the state (blinking or not blinking) of the LED on the specified module.
To blink or unblink the chassis, I/O modules or the CMC, you must have the Debug Administrator privilege. To
enable the servers to blink or unblink, you must have the Server Administrator or the Debug Administrator
privilege.
racadm setled -m <module> -l <ledState>
Synopsis
• -m <module> — Specifies the module whose LED you want to configure.
Input
<module> can be one of the following:
– server–<n>, where n=1–16
– server–<nx>, where n=1–8; x = a, b, c, d (lower case)
– switch–<n>, where n=1–6
– cmc-active
– chassis
• -l <ledState> — Specifies the LED state. The values are:
– 0 — No Blinking
– 1 — Blinking
•
Example
racadm setled -m chassis -l 1
Sets LED state on Chassis to Blink
•
racadm setled -m server-1 -1 1
LED state was set successfully.
NOTE: The server must be turned off to change the slot state. All servers must be turned off to
change the fabric state. The MAC/WWN addresses must be managed locally (not by an external
console) to run this command.
67