•
Synopsis
racadm feature -s
•
racadm feature -d -c <featurename>
•
racadm feature -r -c ExtendedStorage
-s
Input
–Displays the status of active features.
-d
–Deactivates feature specified in -c option.
-r
—Reformats damaged or unformatted extended storage media.
-c
— <featurename> — must be one of the following:
•
flexAddress
•
flexAddressPlus
•
ExtendedStorage (with -d, or -r)
•
Display the current status of all chassis features:
Example
racadm feature -s
•
Deactivate the FlexAddressPlus feature on the chassis:
racadm feature -d -c FlexAddressPlus
featurecard
Description
Verifies proper SD card installation and displays the SD card status.
To use this subcommand, you must have the Chassis Configuration Administrator privilege.
racadm featurecard -s
Synopsis
-s — Lists active SD card features and SD card status.
Input
•
No feature card inserted — Action: To verify that the SD card was properly inserted, check the
Output
CMC. In a redundant CMC configuration, make sure the CMC with the SD feature card installed is the
active CMC and not the standby CMC.
•
The feature card inserted is valid and contains the following feature(s)
FlexAddress: The feature card is bound to this chassis — Action: No action
required.
•
No features active on the chassis — Action: Install the SD card into the CMC.
•
The feature card inserted is valid and contains the following feature(s)
FlexAddress: The feature card is bound to another chassis, svctag =
ABC1234, SD card SN = 01122334455
Action: Remove the SD card; locate and install the SD card for the current chassis.
NOTE: To deactivate FlexAddress features, the chassis must be turned off.
NOTE: When the FlexAddress and FlexAddressPlus feature are active, deactivating one of them
results in deactivation of the other feature also.
CAUTION: Using the -r switch deactivates the extended storage feature, if active; reformats the SD
card in the active CMC card slot; and may Restart the active CMC.
NOTE: The —a option is not supported for CMC 5.0.
23