Cad Condition - Panasonic LP-310 Operation Manual

3-5-4 CAD Condition

On the CAD condition screen, the conditions for setting the marking of the data created by AutoCAD and so
on (DXF file) are set.
1
2
3
4
5
8
9
Item
1. CAD No.
2. CAD File
3. Font
4. Size Appoint
5. Size
6. Laser Power Revise
7. Scan Speed Revise
8. Origin
9. X/Y Position
10. Rotation Angle
11. CAD Cond. COPY
12. CAD Cond. PASTE
13. CAD Cond. DELETE
120
11
Description
Selects the registration No. of the CAD data to be marked
using the list box.
Selects CAD file to be marked.
Selects the font to be used for displaying the character by
the setting software and for marking by the laser marker in
case that the character is used for each CAD file.
Specifies the method of either converting read image data
with leaving the ratio between the height and width, or con-
verting the data with specifying both the height and width
(regardless of the ratio between the height and width).
Specifies the size of X/Y directions of the rectangle to
which a converted CAD data are circumscribed.
Enables to set the correction for the laser power set on the
laser setting screen.
Enables to set the correction for the scan speed set on the
laser setting screen.
Specifies which part of the graphic is aligned to the origin
(0, 0) of the coordinate system.
Moves the origin of the CAD file data in the X direction for the
X position and in the Y direction for the Y position respectively.
Rotates CAD file data around the position of the origin. The
counterclockwise direction is the forward direction.
Copies the whole CAD condition.
Pastes the whole CAD condition copied to the condition with
other CAD No.
Deletes whole CAD condition.
12 13
6
7
10
Setting Range
1 to 15
Select file using
the list box.
Select font using
the list box.
•
X/Y-Same
•
X/Y-Appoint
•
X-Appoint
•
Y-Appoint
0.03 to 50.00mm
(Step: 0.01mm)
0 to 200%
50 to 200%
Select 6 locations
on a graphic.
+/-25.00mm
(Step: 0.01mm)
+/-180.0 °
(Step: 0.1° )
-
-
-