When Using Laser Marker For The First Time - Panasonic LP-310 Operation Manual

2-1

When Using Laser Marker for the First Time

The procedure for using the laser marker for the first time after purchasing from performing test marking the
character (sample show below) until turning off the power supply is described below.
Sample
■
Character
Height
Setting
Value
4mm
Start Coordinate
X: -20mm, Y: 5mm
The position and size of the character to be marked are set as follows:
Start Coordinate X
Character Height
Character Width
Character Interval
* The actual marked character size is differed from the setting character height and character width.
Refer to "3-5-3 Character Condition" (P.115) for details.
Flow Chart
■
1. Preparation of laser marker operation.
(1) Package Check
(2) Installation of Laser Marker
(3) Installation of "LP-300 series PC Setting Software" to PC
(4) Connecting Laser Marker
The details of these procedures are described in "2-1-1 Preparation of Laser Marker Operation" (P.47).
2. Startup of laser marker operation1.
The detail of this procedure is described in "2-1-2 Startup of Laser Marker" (P.48)
3. Procedure from Laser Marker Setting to Test Marking
(1) Set the file to be marked.
(2) Input the character to be marked.
(3) Set the marking condition.
(4) Set the laser.
(5) Perform test marking in personal control mode from the personal computer.
(6) Save setting contents.
The detail of these procedures are described in "2-1-3 Procedure from Laser Marker Setting to Test Marking" (P.49).
Turn off the power of the laser marker.
The detail is described in "2-1-4 Turn OFF Power of Laser Marker" (P.57).
46
Interval Setting Value 5mm
ABCD
Character Width
Setting Value
4mm
: -20mm, Y: 5mm
: 4mm
: 4mm
: 5mm
Laser Power : 30
Scanning Speed : 300
.