(2) System Offset
Move the position of the whole file to the X or Y direction.
Setting Range
Use this parameter to correct the error specific to the laser marker or the error at setting.
REFERENCE
(3) Communication Port
Set the communication port for controlling the laser marker using the communication.
Item
Specifies the communication speed of the transmission/
Baud rate
reception. This value indicates the information capacity
sent/received in one second.
Specifies an error detection bit to each information
Parity
delimited by a stop bit.
Specifies the length of the delimiter signal of the information
Stop bit
sent/received.
Specifies an error detection code to each information
Checksum
delimited by a delimiter.
Specifies a symbol of rough separation on the informa-
Delimiter
tion sent/received.
Refer to "4 External Control" (P.155) for details of the control of the laser marker using the com-
munication.
REFERENCE
:
-2.00 to +2.00mm
Outline
Setting Range
1200/2400/4800/9600/19200/
38400
Select in the list box.
NA/Odd/Even
Select in the list box.
1 bit/2 bit
Select in the list box.
NA/Available
Select in the list box.
CR/CR+LF
Select in the list box.
151