Panasonic LP-310 Operation Manual page 185

7. Marking status transmission permission (code: MST)
(1) Marking status transmission permission setting
This command sets the transmission permission/prohibition of the response indicating the laser marker
status at the end of the marking. Note that the transmission permission/prohibition data is initialized into
"transmission prohibition" after turning OFF the power supply of the laser marker.
STX MST
As for the response data, either normal reception response data or abnormal reception response data is
returned.
Refer to "Response Data" (P.174) for details of both normal reception response data and abnormal recep-
tion response data.
(2) Marking status transmission permission setting readout
This command reads out the response transmission permission/prohibition.
STX MST
As for the response data, either normal reception response data or abnormal reception response data is
returned.
Refer to "Response Data" (P.174) for details of the abnormal reception response data.
Readout response data

STX MST
Description of data

Name
length
Transmission
permission/
prohibition
Data transmission after setting marking status transmission permission
If the marking trigger signal from the external I/O and the marking trigger command through the
communication control are accepted after the marking status transmission permission is set, the status is
set after the marking operation is finished.
Readout data

STX MST
Description of data

Name
length
Status
Error code during marking operation
Indication
-
E04
E10
E11
E12
E20
E21
E22
E23
E25
E26
S [Transmission perm. / proh.] (1 Byte)
R (Check sum)
A [Transmission perm. / proh.] (1 Byte)
Data
Indicates the permission/prohibition of the
1
response transmission.
A [Status] (2 Bytes)
Data
Indicates the status during marking
2
operation.
Status
00 Normal marking operation
04 No setting file
10 Under marking Remote interlock connector OPEN
11 Under marking Laser radiation stop input
12 Under marking Shutter operated
20 Cover OPEN
21
X/Y galvanometers error
22
23 Laser error
25 Marking file error
26 Area over
Delimiter
Outline
Check sum
Outline
Description
(Check sum) Delimiter
(Check sum) Delimiter
Content
"0"•••Transmission prohibited
"1"•••Transmission permitted
Delimiter
Content
"00"•••Finished marking normally
Others•••Occurred error code
during marking operation
185