I/O Connector - Panasonic LP-310 Operation Manual

4-1-2

I/O Connector

Appearance of Connector
■
Lase r Marker Side Co nne ct or Type
User Side Co nnect or Type
*As a user si de conn ecto r, fo llow ing it ems are at tach ed to t hi s pro duct .
[ At tached i te m] User Si de Con nect or
[ At tached i te m] User Si de Con nect or C over
Connecting Sample (In case of operating laser marker standalone)
■
Interlock Input Terminal
(Power Supply BOX)
I/O Connector
* Example when only the file No. 1 is used. To change the files, connect the pin No. 5 to 8 and 18 to 20 (D0 to D6)
to the external control device.
•
If not connecting the power supply (either internal power supply or external power supply) to the
I/O connectors No. 14
For activating the laser marker, connect the power supply (either internal power supply or external
power supply).
•
When performing marking, connect the I/O connector No. 1
INTERLOCK
activated and the marking becomes invalid.
Be sure to connect the interlock terminals on the connecting point. (24V 500mA)
CHECK
•
When performing marking, connect the I/O connectors No. 4
OUT COM.
When setting the state between No. 4 and No. 15 into OPEN, the laser radiation is activated, and
the marking becomes invalid.
•
When the interlock is short-circuited from OPEN, the head panel is displayed rotationally.
While the head panel is displayed rotationally, the marking ready READY becomes OFF, and
the laser marker does not perform marking.
Laser Marker side
: F emale D-sub 2 5 pin
: Male D -su b 25 pin *
1. INTERLOCK COM.
3. INTERLOCK
1. +12V
2. 0V
3. TRIG. IN
4. LASER STOP
14. IN COM.
15. OUT COM.
IN COM.
and No. 15
. When setting the state between No. 1 and No. 3 into OPEN, the emergency stop is
.
User side
: HDBB-25 P (Hi ro se El ect oric C o. , Ltd. )
: HDB-CT F (Hirose Ele cto ri c Co ., Ltd .)
OUT COM.
, the laser marker is not activated.
INTERLOCK COM.
LASER STOP
To Emergency
Stop Switch
12V
To Sensor
0V
To Manual Door
and No. 3
and No. 15
157