Panasonic LP-310 Operation Manual page 20

Detaching Method of Battery
◆
The method for detaching the used battery installed in the laser marker to be disposed is described below in
accordance with the EU Battery Directive (2006/66/EC).
•
When detaching the used battery, be sure to disconnect the power cable so that the power shall
not be supplied to the device.
CAUTION
•
This method is never described with the replacing method of the battery. The battery is replaced
by our service section. Please contact our sales office.
Note that the indication of the life duration of the battery might be 10 years.
CHECK
Remove the rear cover of the head.
1
Remove 10 screws of the rear cover as shown in the figure below, and then slide the cover
backward.
After removing the cover, the battery is installed in the position as shown in the figure below
(surrounded with circle).
Remove the used battery.
2
Remove the adhesive used for enhansing the installation of the battery to the board using the
nipper.
Then, cut the terminal of the battery one by one, and remove the battery from the board.
•
Be sure to cut the terminal of the battery one by one. Cutting two terminals of the battery at the
same time might cause the electrical shock.
CAUTION
20