Procedure For Bottom Installation - Motorola SC 4812ET RF Hardware Installation Manual

Procedure for Bottom
Installation
Table 5-22: Procedure to Install the Main RF Cabling through the Bottom of the RF Cabinet
Step
1 Remove the panel that covers the RF I/O area (see Figure 5-7).
2 Route the Main RF antenna (I) cables through the bottom of the RF Cabinet.
NOTE
If conduit is not used, cables must be strain relieved.
3 Connect the Main RF antenna cables (I) to the bulkhead connectors on the rear wall of the RF Cabinet,
making sure to connect the correct antenna cable to the correct DRDC or TRDC (see Table 5-17 for a
three (3) sector configuration and see Table 5-18 for a six (6) sector configuration).
4 Replace the RF I/O area cover panel if desired.
Apr 2001
SC
TM
V05.03
All antenna RF cabling should be protected with ice
bridge.
Refer to Figure 5-7 and follow the procedures in Table 5-22 to install the
Main RF antenna cable through the bottom of the RF Cabinet.
The bend radius of the RF cables is restricted when
installed through the bottom of the cabinet.
4812ET RF and Power Cabinet Hardware Installation Manual
DRAFT
NOTE
Action
NOTE
Cabinet Cabling
– continued
105
5