Table of Contents
Advertisement
n
Site Consideration
DC Power Connection
Supplied
Transmission Cable &
Conduit
Crane Available or
scheduled
RF and Power Cabinet Installation
Concrete Pad Mounting
Table C-2: Site Preparation and Cabinet Mounting on a Concrete Pad
Step
NOTE
1
– If constructing a new concrete pad, follow the procedures detailed in Chapter 2 "New Concrete
Pad Installation" in the manual.
– Drill the cabinet mounting holes per the procedures in Chapter 2 of the manual. Motorola
recommended anchor bolts require 18 mm (11/16") drill size.
2
Verify that the mounting holes have been drilled in the proper locations.
3
Install the cabinet per the procedures in Chapter 4 of the manual. If the recommended anchor bolts are
used, they should be tightened to a torque of 80 N–m (60 ft–lbs).
Rooftop or Other Structure
Mounting
Table C-3: Site Preparation and Cabinet Mounting on a Rooftop
Step
1
Review the roof load carrying limits, and ensure that the appropriate support structure is in place.
2
Install the cabinet per the procedure in Chapter 4 of the manual. If the Motorola supplied mounting
bolts are used, they should be tightened to a torque of 80 N–m (60 ft–lbs).
Apr 2001
SC
TM
V0C.03
Table C-1: Site Considerations
#2/0 AWG Cable Shipped with Power Cabinet (length = 12 ft.); 3" Trade
Size Conduit
See chapter 2 in the manual for dB loss per foot, minimum bending radius,
and conduit information
If required
The following tables include site preparation and step–by–step
procedures for mounting the SC4812ET RF and Power Cabinets.
Table C-2 covers the cabinet mounting instructions on a concrete pad,
this procedure should be followed for both the RF and Power Cabinet.
Table C-3 covers the cabinet mounting instructions on a rooftop or other
structure, this procedure should be followed for both the RF and Power
Cabinet.
4812ET RF and Power Cabinet Hardware Installation Manual
References and Recommendations
Action
Action
DRAFT
Installation Quickstart
– continued
C
139
Advertisement
Chapters
Table of Contents
