Table of Contents
Advertisement
This section includes...
Scope and Introduction
Tools Needed
Required documents
Apr 2001
SC
TM
V0G.01
Scope and Introduction
Tools Needed
Required documents
Installing an EMPC in a SC 4812ET RF Starter Frame
Connecting an SC 4812ET Starter BTS to an Companion Frame
Tables
Table G-1: Installing an EMPC in the SC 4812ET Starter Frame
Table G-2: Connecting 4812ET RF Starter to RF Companion
Figures
Figure G-1: RX Expansion Cabling of 4812ET to 4812ET BTS
The purpose of this information is to provide instructions on how to
install a SC 4812ET to SC 4812ET companion frame configuration. This
procedure assumes that the SC 4812ET has been previously installed,
optimized, tested and is in operation.
Interconnection ports are included in the SC 4812ET to SC 4812ET
inter–cabinet cabling diagram (see Figure G-1).
– 10 mm Nut Driver
– TORX T15 Screw Driver
– SMA torque wrench or 5/16" wrench if not available
– Type N torque wrench or 11/16" wrench if not available.
– SC 4812ET RF and Power Cabinet Installation manual (Motorola
part number 68P64114A22).
– SC 4812ET RF Cabinet Optimization/ATP manuals (Motorola part
number 68P64114A23 and 68P64114A42).
– SC 614T 2nd Carrier Optimization/ATP manual (Motorola part
number 68P64113A61)
4812ET RF and Power Cabinet Hardware Installation Manual
Appendix G: SC 4812ET – SC 4812ET
Companion Frame Installation
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DRAFT
177
177
177
. . . . . . .
178
178
178
.
178
179
G
177
Advertisement
Chapters
Table of Contents
