Motorola SC 4812ET RF Hardware Installation Manual page 69

Figure 4-1: Front Cabinet Door Hinge (Close-up View)
Existing Concrete Pad
Mounting Procedure
Apr 2001
SC
TM
V04.03
Mounting the cabinet on a pre–existing concrete pad requires that the
mounting holes be drilled using the procedures in Chapter 2 of this
manual. Follow the procedures in Table 4-2 to mount each cabinet.
Step
1 Fasten mounting brackets (see Figure 4-2) onto cabinet with
M12 bolts (supplied in installation hardware). Do NOT torque
the bolts yet. Align the cabinet over the mounting holes.
! CAUTION
Do NOT use the cabinet doors as a hand hold to move the
cabinet around, this could damage the door hinges
2 Install the anchor bolts in the four (4) mounting locations in
the mounting brackets attached to the cabinet base. Tighten
the bolts to proper torque recommended by the manufacturer.
n WARNING
Motorola recommended anchor bolts must be used to assure
safety in the event of an earthquake (CGDS97400036). These
bolts should be tightened to 80 N–m (60 ft–lbs.).
3 Tighten the M12 bolts attaching the mounting brackets to the
cabinet, torque to 135 N–m (100 ft–lbs) with a 19mm (3/4")
torque wrench.
4812ET RF and Power Cabinet Hardware Installation Manual
DRAFT
Loosen this screw to remove door
(Top and Bottom Hinges)
Table 4-2: Concrete Pad Mounting
Action
Cabinet Mounting
– continued
. . . continued on next page
69
4