A V0A.03; Installing Rgps - Motorola SC 4812ET RF Hardware Installation Manual

This section includes...
Introduction
Installation Procedure
Step
1 Determine the mounting location (see RGPS Mounting Considerations).
2 Install the mounting brackets onto the RGPS location of choice. Use the appropriate mounting bolts
for mounting surface.
n WARNING
The structure of the wall should be verified by a qualified structural engineer for the weight of the
RGPS engine and mounting hardware or under adverse conditions for the installation area.
! CAUTION
Mounting the RGPS antenna and hardware to an inadequate wall structure and/or using inadequate
installment methods can result in serious injury.
Apr 2001
SC
TM
V0A.03
Introduction
Installation Procedure
RGPS Mounting Considerations
Tables
Installing the RGPS
Figures
Figure A-1 Remote GPS Mounting
The objective of this procedure is to install the BTS Remote Global
Positioning System receiver (RGPS) antenna.
The cable between the BTS and the RGPS head is 22 AWG
12–conductor wire configured as six twisted pairs. Power for the RGPS
head is provided by the BTS via the 12–conductor cable, refer to Chapter
5 for details.
Table A-1 lists the procedures for installing the RGPS system.
Table A-1: Installing the RGPS
4812ET RF and Power Cabinet Hardware Installation Manual
Appendix A: Installing RGPS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . .
Action
DRAFT
123
123
125
123
124
. . . continued on next page
123
A