Overview; Indoor Location - Motorola SC 4812ET RF Hardware Installation Manual

Site Preparation
– continued
2

Overview

Indoor Location

34
Figure 2-3: Grounding Ring Detail
Figure 2-4: Conduit Stub Height Detail
Figure 2-5: Cabinet Dimensions
Figure 2-6: Pad Forms and Conduit Layout
Figure 2-7: Mounting Hole Dimensions
Figure 2-8: SC 4812ET RF Cabinet Conduit I/O
Figure 2-9: SC 4812ET Power Cabinet Conduit I/O
This chapter covers the SC 4812ET BTS site preparation recommended
guidelines.
Installation sites can be classified into one of the three following
categories: Indoor, Rooftop or Outdoor.
All applications will have common requirements and considerations.
Differences between the location site requirements will be covered
throughout the installation section. The following information is meant
to serve as a guideline and can be impacted by site specific
considerations.
*
The following items should be considered when choosing an indoor
location for the SC 4812ET BTS:
– A permanent location is more desirable than a temporary one.
– The cabinets should be placed in a location with appropriate
clearance from any obstructions. For minimum clearances see
Chapter 1.
SC 4812ET RF and Power Cabinet Hardware Installation Manual
TM
. . . . . . . . . . . . . . . . . . . . . . . . .
WARNING
Every effort should be made to provide a safe working area
for all installation and service personnel.
CAUTION
The mounting surface must be flat. Door closure problems
may occur if the cabinets are not installed on a flat surface.
IMPORTANT
Care should be taken to ensure that the AC power pedestal
does not interfere with the future addition of expansion or
optional equipment service area.
DRAFT
. . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . .
. . . continued on next page
53
53
54
55
55
56
57
Apr 2001
V02.03