Overview - Motorola SC 4812ET RF Hardware Installation Manual

Overview

Review the Material
Apr 2001
SC
TM
V05.03
Figure 5-9: Power Cabinet Punch Block
Figure 5-10: Connecting Power Cables
Figure 5-11: AC Load Center Wiring
This chapter provides the SC 4812ET RF and Power Cabinet
inter-cabinet cabling procedures.
Before starting to install cables, it is recommended that you become
familiar with the equipment and the cable connection locations. You can
start by reviewing the information found in this chapter.
4812ET RF and Power Cabinet Hardware Installation Manual
DRAFT
. . . . . . . . . . . . . . . . . . . . .
WARNING
– Do NOT wear a wrist strap when servicing the power
supplies or power distribution cabling. Serious
personal injury can result.
– Before starting the procedure, ensure that the Power
Cabinet power cables are not connected to the main
source.
CAUTION
– Static sensitive equipment requires that ESD
protective gear such, as a wriststrap, be used during
the installation and repair.
– A wriststrap is supplied with the installation hardware
and a jack is in the C–CCP Cage in the RF Cabinet
(See Figure 1-6).
Cabinet Cabling
– continued
. . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . .
108
111
116
5
83