Fujitsu ETERNUS DX60 S3 User Manual page 175

Chapter 3 Component Status
3.24 Port Detail
- Port Mode
The port mode is displayed.
• CA
• RA
• CA/RA
• Initiator
- Status
The port status is displayed. Refer to
- Status Code
The port status code is displayed.
- Error Code
The port error code is displayed.
- Type
The port type (fixed to "FC") is displayed.
- Connection
The connection type of the port is displayed.
• Fabric
A connection type that enables simultaneous communication among multiple nodes through a
Fibre Channel switch. This connection type can also be used for a direct connection when "Transfer
Rate" is "16 Gbit/s".
• FC-AL
A connection type that connects multiple nodes in a loop.
- Loop ID
If the connection type of the target port is "FC-AL", the Loop ID is displayed.
When the Loop ID is manually specified, the ID that is to be set for the port is displayed in hexadecimal.
When the Loop ID is automatically specified, "Ascending" or "Descending" is displayed.
When the "Connection" is "Fabric", a "-" (hyphen) is displayed.
- Class
The service class of the port (fixed to "Class3") is displayed.
- Transfer Rate
The transfer speed of the port is displayed.
If the status is "
• Auto-negotiation
• 4 Gbit/s
• 8 Gbit/s
• 16 Gbit/s
- Link Status
The link status of the port is displayed.
If the status is "
• Link Down
• 4 Gbit/s Link Up
• 8 Gbit/s Link Up
• 16 Gbit/s Link Up
"A.5 Component Status" (page 410)
Unknown", a "-" (hyphen) is displayed.
Unknown", a "-" (hyphen) is displayed.
175
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED
for details.
P2X0-1260-19ENZ0