Fujitsu ETERNUS DX60 S3 User Manual page 38

Chapter 2 System Status
2.1 System (Basic Information)
• Virtual Volume
Whether the Virtual Volume function is enabled or disabled is displayed.
The Virtual Volume function cannot be set with Web GUI. To set the Virtual Volume function, use ETERNUS
SF Storage Cruiser.
For the ETERNUS DX60 S3, this item is not displayed.
• Serial Number
The serial number of the ETERNUS DX/AF is displayed.
• WWN
The WWN of the ETERNUS DX/AF is displayed.
• Firmware Version
The current controller firmware version is displayed.
- VxxLyy-zzzz (Vxx: Version, Lyy: Level, zzzz: Release number)
• Status
General status (detail) of the ETERNUS DX/AF is displayed. Refer to
(page 404)
• Cache Mode
The current status and the factor of the cache are displayed. The normal status is "Write Back Mode".
Refer to "Cache Mode" (page 26)
- Write Back Mode
- Write Through (Pinned Data)
- Write Through (Battery)
- Write Through (Maintenance)
- Write Through (1CM)
• Remote Support
The Remote Support status (REMCS or AIS Connect) is displayed. If the Remote Support is not set, a "-"
(hyphen) is displayed.
- Operating
The Remote Support is operating.
- Maintenance in Progress
The ETERNUS DX/AF is under maintenance and the Remote Support is temporarily stopped.
After the maintenance is complete, Remote Support is automatically resumed.
- Stopped
The Remote Support is stopped.
• Operation Mode
The operation mode is displayed.
- Normal
The ETERNUS DX/AF is in operation.
- Maintenance Mode
The ETERNUS DX/AF is under maintenance.
• Connecting Module
The CM to which ETERNUS Web GUI is connected is displayed.
for details.
in "1.1 Overview"
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED
"A.1 Storage System General Status"
for details.
38
P2X0-1260-19ENZ0