HandyTool
HandyTool
Note
Siemens
Building Technologies
10.16
Software version
The present software version can be read via the HandyTool.
Parameter
Application set
Application version
Operating system version
KNX interface version
*) This information serves to identify the controller's software version. You can use it in
case of a service request.
10.17
Device state
If the application is ready (loaded and tested), parameter 240 is set to 1.
Parameter
Device state
In Service mode the device state is always = 0 because the application is not running.
RXB (KNX) Applications library
General / central functions
HandyTool
*236
42A = RXB24.1/CC-02
42B = RXL24.1/CC-02
*237 *)
*238 *)
*239 *)
HandyTool
*240
CLC and RAD description of functions for CC-02 CM110384en_03
113/140
28 Feb 2009