Supported Tools; Parameter Setting With Ets3 Professional - Siemens Desigo RXB Technical Manual

Note!
STOP
ETS3 Professional
Siemens
Building Technologies
2.2

Supported tools

The RXB Konnex controllers can be commissioned either with the Konnex tool ETS3
Professional, the Synco ACS Service too or the HandyTool.
• Be careful when using different tools. The following rule applies:
Last one's right!
• If you use OCI700 as an interface, it is connected to the service plug of the controller
or of the room unit.
As long as the OCI700 is connected to the service plug, it must be supplied by
the computer via the USB interface. Otherwise the LCD display of the room unit
will turn dark and the controller will switch to addressing mode.
2.3

Parameter setting with ETS3 Professional

This manual does not describe how the physical address is defined.
Refer to the EIB manual for more details.
Open the project and select a device.
To start the parameter setting, select Edit, Edit parameters.
RXB (KNX) application library
Definitions / Tools
FNC Description of functions for FC-10, FC-11, FC-12
13/166
CM110385en_05
28 Feb 2009