Adjusting The Pressure Of The Deck/Cassette Separation Roller - Canon imageRUNNER 5065 series Service Manual

sure the belt pulley [2] is at the front of the machine.
Check to make sure the protrusion in the roller plate and roller are engaged
securely.
front
[2]
14.8.4 Adjusting the Pressure of the Deck/Cassette
Separation Roller
iR5065 / iR 5055 / iR5075 / / /
When picking up, if double feeding or pickup failure occurs, adjust the posi-
tion of the pressure spring in the separation roller.
- If double feeding occurs, move the hook of the spring in the direction of
B.
- If pickup failure occurs, move the hook of the spring in the direction of
A.
A
B
[1] Feeding roller
[2] Separation roller
[3] Pressure lever
[4] Pressure spring
14.8.5 Adjusting the Pressure of the Manual Separation
Roller
iR5065 / iR 5055 / iR5075 / / /
When picking up, if double feeding or failure occurs, adjust the position of
the pressure spring of the separation roller.
1) Detach the right cover (upper).
2) Remove the upper guide [1].
3) Move the mount [3] to adjust the position of the pressure spring of the
separation roller.
- If double feeding occurs, remove the mounting screw [2], lower the
[1]
rear
F-14-64
[1]
[2]
[3]
[4]
F-14-65
[1]
F-14-66
mounting base [3] and tighten the screw [2] in the A hole.
- If pickup failure occurs, remove the mounting screw [2], raise the
mounting base [3] and tighten the screw [2] in the B hole.
14.8.6 Adjusting the Position of the Pickup Solenoid (SL3,
SL4) of the Cassette 3/4
iR5065 / iR 5055 / iR5075 / / /
Adjust the position of the solenoid using the two screws [3] so that the dis-
tance from the bottom of the pickup assembly to A of the roller arm is 36-/
+0.5 mm when [1] and [2] are op-erated.
0016-0023
[2]
14.8.7 Adjusting the Position of the Delivery Flapper
Solenoid (SL5)
iR5065 / iR 5055 / iR5075 / / /
Adjust the position of the mounting screw [2] using the screw [2] so that the
drive lever [1] is pushed fully when the solenoid turns on (i.e., when the
plunger is drawn).
0016-0025
14.8.8 Adjusting the Position of the Right Deck Pickup
Solenoid (SL6)
iR5065 / iR 5055 / iR5075 / / /
Adjust the position of the solenoid so that the left edge of the arm 2 is 57.2 -
/+0.5 mm from the center of hole A of the solenoid mounting base.
hole A [1]
[2]
hole B
F-14-67
[1]
[2]
A
[3]
A
F-14-68
[1]
[2]
F-14-69
Chapter 14
0015-5326
[1]
0015-5327
0015-5328
14-23