Adjust (Adjustment Mode); Copier; Copier List - Canon imageRUNNER 5065 series Service Manual

Address

17.4 ADJUST (Adjustment Mode)

17.4.1 COPIER

17.4.1.1 COPIER List

iR5065 / iR 5055 / iR5075 / / /
<AE>
Sub-item Description
AE-TBL adjustment range: 1 to 9 (default: 5)
- to obtain darker characters, increase the setting.
- to obtain lighter characters, decrease the setting.
If you have initialized the RAM on the reader controller PCB, enter the value indicated on the service label.
<ADJ-XY>
bit Description
P020 0 registration clutch ON signal
1-4 not used
5 pre-registration motor clock signal
6 not used
7 duplexing right feed motor clock signal
P021 0 not used
1 DDI-TxD
2 not used
3 DDI-RxD
4 DDI-POWER
5 DDI-SCNST
6-7 not used
P022 0-7 not used
P023 0 FIN-RESET
1 FIN-MODE
2-7 not used
P024 0-4 not used
5 pulse count INT
6 DMA-END-INT
7 DMA-REQ-INT
P025 0 deck open detecting switch signal
1 deck paper absent sensor signal
2 deck lifter upper limit sensor signal
3 deck pickup sensor signal
4 deck feed sensor signal
5 deck pickup clutch ON signal
6 not used
7 deck paper supply position sensor signal
P026 0 deck paper level sensor signal
1 deck lifter lower limit detection signal
2 deck set sensor signal
3 deck open sensor signal
4 deck ID1
5 deck ID2
6 not used
7 switchover of the large/small deck
P027 0 deck open LED ON signal
1 deck pickup roller release solenoid drive signal
2 not used
3 deck pickup clutch drive signal
4-5 not used
6 deck main motor drive signal
7 deck lifter motor drive signal
P028 0 deck lifer lower limit detection signal
1 deck open solenoid
2 deck main motor constant current setting
3-7 not used
T-17-16
COPIER > ADJUST > AE
Remarks
0: closed
1: paper present
1: upper limit
1: paper present
1: paper present
1:ON
1:ON
1: paper present
1: lower limit
1: connected
1: closed
1: connected
0: connected
1:ON
1:ON
1:ON
1:ON
1:ON
1:ON
1:ON
1:ON
Level
Chapter 17
0015-5840
1
17-21