Applying Grease After Replacing The Fixing Roller - Canon imageRUNNER 5065 series Service Manual

[2]
F-9-50
[3]
F-9-51
- When fixing the core positioning plate [1] (both front and rear sides)
with screws [2] after mounting the fixing roller, tighten the screws while
pushing the bearing [3] of the fixing roller downward with finger. This is
to eliminate the gap [A] between the bearing and the fixing frame. This
work should be properly done, or the gap in the joint is likely to cause the
fixing fault or paper wrinkles.
[2]
[3]
[2]
F-9-52
[1]
[1]
[2]
[1]
[2]
[3] [A]
- Be sure to remove the paper around the roller after mounting the fixing
roller to the fixing unit.
- Be sure to fit the 2 pins [1] back to the initial positions. If this is undone
when turning the main power switch on, 'E840' error will be returned. If
turning on the main power switch with the only one pin fit, this will cause
not only the 'E840' error but also the shutter distortion.
[1]
[1]

9.5.4.4 Applying Grease After Replacing the Fixing Roller

iR5065 / iR 5055 / iR5075 / / /
- About 20mg of grease (Molykote HP-300; CK-8012) should be applied
to the inner [1] and the outer surfaces [2] of the bushing until the white
coat covering is formed uniformly. If this undone, the noise (squeaking)
may occur.
Chapter 9
[3]
F-9-53
F-9-54
0015-9975
9-23