Service Mode Screen Configuration; Entering Or Selecting Service Modes; Outline - Canon imageRUNNER 5065 series Service Manual

17.1 Outline

17.1.1 Service mode screen configuration

iR5065 / iR 5055 / iR5075 / / /
As shown below, the service modes use three screen levels: initial screen -> main/intermediate item screen -> sub-item screen.
One set of modes are used for normal maintenance (Level 1 modes), and another set are used for troubleshooting (Level 2 modes).
The copier has the 7 service modes listed below.

17.1.2 Entering or selecting service modes

iR5065 / iR 5055 / iR5075 / / /
To execute a copier operation using a service mode, remove the cable from the external controller or the cable from the network before entering the desired mode.
Take care when using the FUNCTION (operation/inspection mode) mode, as the copier may malfunction and be damaged if a print job is received from outside
while an operation is executing with this mode in effect.
User screen
( )(2,8)( )
Reset key
Initial screen
(Level 1)
(Select an item.)
Main/intermediate
item screen
(Level 1)
(Select a main item from the top of screen.)
(The corresponding intermediate items are
then displayed and can be selected.)
Sub-item screen Sub-item screen
(Level 1) (Level 1)
Previous/next page
COPIER
FEEDER
SORTER
BOARD
Initial screen
( )(2) (Level 2)
(Select an item.)
Main/intermediate
item screen
(Level 2)
Sub-item screen
(Level 2)
F-17-1
DISPLAY Status display mode
I/O I/O display mode
ADJUST Adjustment mode
FUNCTION Operation/inspection mode
OPTION Specifications setting mode
TEST Test print mode
COUNTER Counter mode
F-17-2
(Select a main item from the top of screen.)
(The corresponding intermediate items are
then displayed and can be selected.)
Sub-item screen
(Level 2)
Previous/next page
Chapter 17
0015-5495
0015-5497
17-1