Huawei NetCol5000-A User Manual page 127

NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm)



Procedure


Issue 13 (2019-01-15)
You can calibrate the screen by DIP switch only when the system enters Quick Settings
page after the first power-on or when the system is on the home screen.
Touch the LCD screen firmly if you are using your fingertips. It is recommended that you
use the pen tip for accurate selection and quick response.
After the DIP switch is calibrated, flip toggle switch 1 to ON, and others to the opposite
position.
When calibrating the screen by tapping the screen, tap Maint > Screen Calib to enter
the following screen, as shown in
calibration is complete.
Figure 4-44 Screen calibration page
Figure 4-45 Screen displayed when the calibration is complete
Calibrating the screen by DIP switch.
a. Flip toggle switch 1 for the LCD to ON, and others to the opposite position, and
wait for 3 seconds before calibrating. Figure 1 shows the toggle switches for the
screen.
Copyright © Huawei Technologies Co., Ltd.
Figure 4-44. Figure 4-45
4 ACC Introduction
is displayed when the screen
118