Connecting Monitoring Cable From Fe Port - Huawei NetCol5000-A User Manual

NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm)


Table 3-17 DIP switch operation description
Positi
on
Return
air side
Cold
aisle
Hot
aisle

3.11.7 Connecting Monitoring Cable from FE Port

When remote upgrade is needed, connect one end of the monitoring cable (standard network
cable, prepared by yourself) to the FE port in the display panel, as shown in
Connect the other end to the monitoring device.
Issue 13 (2019-01-15)
RS485_R must be switched to OFF.
After the address is set, choose Settings > System Settings > T/H Sensor on the home
page after power-on and set the sensors in the aisle corresponding to the address to Enable.
Otherwise, the sensors will not work.
Name
Temperature and
humidity 1 at the
return air vent
Temperature and
humidity 1 at the
cold aisle
Temperature and
humidity 2 at the
cold aisle
Temperature and
humidity 3 of the
cold aisle
Temperature and
humidity 1 at the
hot aisle
Temperature and
humidity 2 at the
hot aisle
Temperature and
humidity 3 at the
hot aisle
Copyright © Huawei Technologies Co., Ltd.
Addr DIP Switch ID
ess
1 2
1 ON OFF
11 ON ON
12 OFF OFF
13 ON OFF
21 ON OFF
22 OFF ON
23 ON ON
3 Installation Guide
3 4 5
OFF OFF OFF
OFF ON OFF
ON ON OFF
ON ON OFF
ON OFF ON
ON OFF ON
ON OFF ON
Figure
6
OFF
OFF
OFF
OFF
OFF
OFF
OFF
3-53.
76