Removing The Transport Fasteners From The Compressor - Huawei NetCol5000-A User Manual

NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm)
Step 3 Connect the wiring terminals to the high float. The wiring terminals must be fixed higher than
the water pan. Otherwise, water may drop into the wiring terminals.
The wiring terminals must stay in good contact with the floats. Otherwise, the condensate
pump cannot start properly.
Figure 3-13 Removing the transport fasteners from the floats and connecting the wiring terminals
----End

3.4.2 Removing the Transport Fasteners from the Compressor

Context
When removing transport fasteners, do not remove the fuel return solenoid valve. Otherwise,
the solenoid valve might be burnt due to improper reinstallation.
Procedure
Step 1 Loosen the three bolts on the compressor using a 13# solid wrench, as shown in
Do not directly take the bolts out.
Issue 13 (2019-01-15)

The wiring terminal to the low float has been factory installed.

Put away the removed rubber fixing objects. If the container is to be transported again, remove the
wiring terminal from the high float and reinstall them.
Copyright © Huawei Technologies Co., Ltd.
3 Installation Guide
Figure 3-14.
38